2019 ford edge front license plate bracket

Remove the backing on the double sided tape on the horizontal section of each bracket, and carefully align the license plate and bracket assembly once again on the front of your bumper.

These sections should be completely clean and dry to ensure that the double-sided tape on the bracket will adhere well. Alcohol is a good cleaning fluid to use, but soap and water will also work.

Carefully clean the sections on the underside of the bumper you noted in the above step.

Then note the location where the two horizontal bracket sections contact the underside of the bumper. You may need to slightly loosen the angle adjustment screws. Angle the plate to the desired angle with respect to the bumper by adjusting the angle of the left and right brackets. Be sure to center the license plate with your grill.

Position the license plate assembly in the desired location on your front bumper.

Don’t tighten the screws too tightly at this point. Do the same for the left bracket with the other 2 screws and washers.

With the hex key, attach the right bracket to the right rear side of your license plate, using 2 of the 4 included cap screws and 2 of the 4 included stainless steel trim washers.

Tighten each front screw, while ensuring that the horizontal brackets are perpendicular with the slot in the vertical section.

Slide the horizontal section of each bracket so it is this distance from the top end of the vertical brackets. Using the included hex key, loosen the front stainless steel button-head cap screw on the left and right brackets. First, measure the distance from the lower edge of your bumper to where you want the top of your license plate to be.Installation is extremely easy, and takes about 10 minutes.

Our low profile front license plate bracket comes pre-assembled in two parts – a left side and a right side, as illustrated in the sketches above.These step-by-step instructions are included with the bracket.

2019 ford edge front license plate bracket